EMISSION CONTROL SYSTEM (for Hatchback) > ON-VEHICLE INSPECTION |
| 1. INSPECT FUEL CUT-OFF RPM |
Start and warm up the engine.
Increase the engine speed to approximately 3500 rpm.
Using a sound scope, check the operation sound of the injector.
Release the accelerator pedal. Check that the operation noise stops momentarily and then resumes.
| 2. VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS |
![]() |
Check that there are no cracks, leakage or scratches on the hoses, connections or gaskets.
| 3. CHECK LINE AND CONNECTORS |
Visually check for loose connections, sharp bends and damage.
| 4. CHECK FUEL TANK ASSEMBLY |
Visually check for deformation, cracks and fuel leakage.
| 5. CHECK FUEL TANK AND VENT LINE |
Disconnect the vent line hose from the canister.

| *1 | Fuel Tank Cap | *2 | Vent Line Hose |
| *3 | Canister | - | - |
Connect the pressure gauge to the vent line hose.
Apply 4 kPa (41 kgf/cm2, 30 mmHg) of pressure to the vent line of the fuel tank.
Check that the fuel tank pressure is maintained for some time, and does not decrease immediately.
When the fuel tank cap is removed, check that the pressure is released smoothly.
Reconnect the vent line hose to the canister.
| 6. CHECK AIR INLET LINE |
![]() |
| *a | Air |
Disconnect the air inlet line hose from the canister.
Check that air flows freely into the air inlet line.
Reconnect the air inlet line hose to the canister.