Home › Engine / Hybrid System › 1NZ-FE EMISSION CONTROL › PCV VALVE (for Sedan)

PCV VALVE (for Sedan) > INSTALLATION



1. INSTALL VENTILATION VALVE SUB-ASSEMBLY


A105280E02
  1. Apply adhesive to the end 2 or 3 threads of the bolt.

    Adhesive:
    Toyota Genuine Adhesive 1324, Three Bond 1324 or the equivalent.



    A117796
  1. Install the ventilation valve sub-assembly.

    Torque:
    27 N*m{ 275 kgf*cm , 20 ft.*lbf }



2. CONNECT VENTILATION HOSE


A115391


3. INSTALL CYLINDER HEAD COVER NO. 2


A116235E01
  1. Tighten the 2 A nuts, then the 2 B nuts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }