Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › AIR FUEL RATIO SENSOR (for Sedan)

AIR FUEL RATIO SENSOR (for Sedan) > INSTALLATION

for Preparation Click here



1. INSTALL AIR FUEL RATIO SENSOR


A115425E01
  1. Using SST, install the air fuel ratio sensor.

    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    HINT:
    1. This torque value is effective when SST is parallel to the torque wrench.
    2. The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
    3. The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.).
    4. If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values (Click here).

  1. Connect the air fuel ratio sensor connector and the clamp.



2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



3. CHECK FOR EXHAUST GAS LEAK