Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › HEATED OXYGEN SENSOR (for Sedan)

HEATED OXYGEN SENSOR (for Sedan) > INSTALLATION

for Preparation Click here



1. INSTALL HEATED OXYGEN SENSOR


A115424E02
  1. Using SST, install the heated oxygen sensor onto the front exhaust pipe.

    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    HINT:
    1. This torque value is effective when SST is parallel to the torque wrench.
    2. The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
    3. The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.).
    4. If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values (Click here).

  1. Pass the sensor connector through the floor panel and install the grommet.

  1. Connect the sensor connector.



2. INSTALL INSTRUMENT PAD LOWER LH
  1. Engage the claw and 3 clips and install the instrument pad lower.

  1. Install the <H> screw.



3. INSTALL REAR CONSOLE BOX ASSEMBLY


    B132349
  1. Engage the 4 claws and install the rear console box.

  1. Install the 2 bolts and 2 screws.

  1. Connect the clamp.



4. INSTALL CONSOLE BOX CARPET


    B132346
  1. Install the console box carpet.



5. INSTALL CONSOLE UPPER REAR PANEL SUB-ASSEMBLY


    B132348
  1. Connect the connector.

  1. Engage the 3 clips and 3 claws and install the console upper rear panel.



6. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY


    B132347
  1. Engage the 5 clips and the claw and install the upper console panel.



7. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)


8. INSTALL INSTRUMENT PANEL FINISH PANEL END LH


B132317
  1. Engage the 6 claws and 3 clips and install the instrument panel finish panel end LH.



9. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER


B132316
  1. Engage the 2 claws and 2 clips and install the instrument panel finish panel lower center.



10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



11. CHECK FOR EXHAUST GAS LEAKAGE