Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › HEATED OXYGEN SENSOR (for Sedan)

HEATED OXYGEN SENSOR (for Sedan) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER


B132316
  1. Disengage the 2 claws and 2 clips and remove the instrument panel finish panel lower center.



3. REMOVE INSTRUMENT PANEL FINISH PANEL END LH


B132317
  1. Disengage the 6 claws and 3 clips and remove the instrument panel finish panel end LH.



4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle)


5. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


B132347
  1. Shift the shift lever into the N position.

  1. Disengage the 5 clips and the claw and remove the upper console panel.



6. REMOVE CONSOLE UPPER REAR PANEL SUB-ASSEMBLY


B132348
  1. Disengage the 3 clips and 3 claws.

  1. Disconnect the connector and remove the rear upper console panel.



7. REMOVE CONSOLE BOX CARPET


    B132346
  1. Remove the console box carpet.



8. REMOVE REAR CONSOLE BOX ASSEMBLY


    B132349
  1. Disconnect the clamp.

  1. Remove the 2 bolts and 2 screws.

  1. Disengage the 4 claws and remove the rear console box.



9. REMOVE INSTRUMENT PAD LOWER LH


    B132339
  1. Remove the <H> screw.

  1. Disengage the claw and 3 clips and remove the instrument pad lower.



10. REMOVE HEATED OXYGEN SENSOR
  1. Disconnect the sensor connector.

  1. Remove the grommet and pass the sensor connector out of the cabin through the floor panel.



    A115424E02
  1. Using SST, remove heated oxygen sensor.

    SST
    09224-00010