INTEGRATION RELAY (for Hatchback) > INSPECTION |
| 1. INSPECT NO. 1 INTEGRATION RELAY |
Check the EFI MAIN relay.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1C-1 - 1E-4 | Battery voltage is not applied to terminals 1E-10 and 1D-7 | 10 kΩ or higher |
| Battery voltage is applied to terminals 1E-10 and 1D-7 | Below 1 Ω |
| *a | Component without harness connected (No. 1 Integration Relay) |
Check the C/OPN relay.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1E-4 - 1E-5 | Battery voltage is not applied to terminals 1E-11 and 1D-9 | 10 kΩ or higher |
| Battery voltage is applied to terminals 1E-11 and 1D-9 | Below 1 Ω |
| *a | Component without harness connected (No. 1 Integration Relay) |
Check the IG2 relay.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1C-1 - 1D-9 | Battery voltage is not applied to terminals 1E-10 and 1D-17 | 10 kΩ or higher |
| Battery voltage is applied to terminals 1E-10 and 1D-17 | Below 1 Ω |
| *a | Component without harness connected (No. 1 Integration Relay) |
Check the HORN relay.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1C-1 - 1E-7 | Battery voltage is not applied to terminals 1C-1 and 1D-18 | 10 kΩ or higher |
| Battery voltage is applied to terminals 1C-1 and 1D-18 | Below 1 Ω |
| *a | Component without harness connected (No. 1 Integration Relay) |