Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › INTEGRATION RELAY (for Hatchback)

INTEGRATION RELAY (for Hatchback) > REMOVAL



1. REMOVE ENGINE ROOM MAIN RELAY BLOCK COVER


2. REMOVE NO. 1 INTEGRATION RELAY


    A250507E02
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and disconnect the No. 1 integration relay.
    Text in Illustration 
    *1
    Protective Tape

  1. Disconnect the 3 connectors.