Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › ECM (for Sedan)

ECM (for Sedan) > REMOVAL


NOTICE:
Replace the ECM with a new one if necessary.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT WIPER ARM HEAD CAP


    E127832E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the claw and remove the 2 front wiper arm head caps.



3. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH


    E127833
  1. Operate the wiper, then stop the windshield wiper motor in the automatic stop position.

  1. Remove the nut and front wiper arm.



4. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



5. REMOVE COWL SIDE VENTILATOR SUB-ASSEMBLY LH


    E127834E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the cowl side ventilator sub-assembly LH.



6. REMOVE COWL SIDE VENTILATOR SUB-ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.



7. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY


    E127838
  1. Disengage the 3 clips, the 4 claws and the 8 hooks.

  1. Remove the cowl top ventilator louver sub-assembly.



    E127839
  1. Disconnect the washer hoses.

  1. Disengage the 5 hooks.



8. REMOVE FRONT WIPER MOTOR AND LINK


    E127837
  1. Remove the 2 bolts.

  1. Slide the wiper link. Disengage the meshing of the rubber pin, then disconnect the connector and remove the front wiper motor and link.



9. REMOVE FRONT AIR SHUTTER SEAL


    A133324
  1. Disengage the 3 claws and remove the front air shutter seal.



10. REMOVE COWL TOP PANEL OUTER


    A133322
  1. Disengage the claw and disconnect the wire harness.



    A133326
  1. Remove the 2 bolts and remove the cowl top panel outer center bracket.



    A133328
  1. Remove the 8 bolts and remove the cowl top panel outer.



11. REMOVE ECM


A115384
  1. Remove the 2 lock knobs and harness clamp.



    A115386
  1. Disconnect the 2 ECM connectors.

  1. Remove the bolt and 2 nuts and remove the ECM.



12. REMOVE ECM BRACKET


A115387
  1. Remove the 2 screws and the ECM bracket.



13. REMOVE ECM BRACKET NO. 2


A115388
  1. Remove the 2 screws and ECM bracket No. 2.