Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › ACCELERATOR PEDAL (for Sedan)

ACCELERATOR PEDAL (for Sedan) > INSTALLATION



1. INSTALL ACCELERATOR PEDAL ASSEMBLY

NOTICE:
  1. This accelerator pedal assembly does not require lubrication. Do not apply oil or other lubrication to the accelerator pedal assembly. If applied, the accelerator pedal assembly must be replaced.
  2. Avoid any physical shock to the accelerator pedal assembly.
  3. Do not disassemble the accelerator pedal assembly.



    A115383
  1. Install the accelerator pedal assembly with the 2 bolts.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }

  1. Connect the accelerator pedal assembly connector.