Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › ACCELERATOR PEDAL (for Sedan)

ACCELERATOR PEDAL (for Sedan) > REMOVAL



1. REMOVE ACCELERATOR PEDAL ASSEMBLY

NOTICE:
  1. This accelerator pedal assembly does not require lubrication. Do not apply oil or other lubrication to the accelerator pedal assembly. If applied, the accelerator pedal assembly must be replaced.
  2. Do not drop or strike the accelerator pedal assembly.
  3. Do not disassemble the accelerator pedal assembly.



    A115383
  1. Disconnect the accelerator pedal assembly connector.

  1. Remove the 2 bolts and the accelerator pedal assembly.