ACCELERATOR PEDAL (for Sedan) > ON-VEHICLE INSPECTION |
| 1. INSPECT ACCELERATOR PEDAL ASSEMBLY |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.
Read the value displayed on the Techstream.
| Condition | Accel Sensor Out No. 1 | Accel Sensor Out No. 2 |
| Accelerator pedal released | 0.5 to 1.1 V | 1.2 to 2.0 V |
| Accelerator pedal depressed | 2.6 to 4.5 V | 3.4 to 5.0 V |