Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › THROTTLE BODY (for Sedan)

THROTTLE BODY (for Sedan) > INSPECTION



1. INSPECT THROTTLE WITH MOTOR BODY ASSEMBLY


A115133E01
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      1 (M-) - 2 (M+)
      0.3 to 100 Ω at 20°C (68°F)

      If the result is not as specified, replace the throttle with motor body assembly.