CAMSHAFT OIL CONTROL VALVE (for Sedan) > INSTALLATION |
| 1. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY |
![]() |
Apply a light coat of engine oil to a new O-ring and install it onto the camshaft timing oil control valve assembly.
![]() |
Install the camshaft timing oil control valve assembly with the bolt.
![]() |
Connect the camshaft timing oil control valve assembly connector.
| 2. INSTALL FAN BELT ADJUSTING BAR |
![]() |
Provisionally install the fan belt adjusting bar with the bolt and nut.
Tighten the nut to the specified torque.
| 3. INSTALL FAN AND GENERATOR V BELT |
Provisionally install the fan and generator V belt onto each pulley.
| 4. ADJUST FAN AND GENERATOR V BELT |
![]() |
Insert an adjusting bar between the engine mounting bracket and generator assembly. Pull the adjusting bar toward the vehicle front to adjust the generator V belt tension .
| *a | OK |
| *b | NG |
![]() |
First tighten bolt A, then tighten bolt B.
| 5. INSPECT FAN AND GENERATOR V BELT |
![]() |
Check the belt for wear, cracks or other signs of damage.
If any of the following defects is found, replace the V-ribbed belt.
![]() |
Check that the belt fits properly in the ribbed grooves.
| *a | CORRECT |
| *b | INCORRECT |
![]() |
Inspect the V belt deflection and tension.
| *A | w/o Air Conditioner |
| *B | w/ Air Conditioner |
| Item | Specified Condition |
| New belt | 8.0 to 9.0 mm (0.31 to 0.35 in) |
| Used belt | 12.5 to 13.5 mm (0.49 to 0.53 in) |
| Item | Specified Condition |
| New belt | 700 to 800 N (71 to 82 kg, 157 to 180 lb) |
| Used belt | 300 to 400 N (31 to 41 kg, 67 to 90 lb) |
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 7. CHECK FOR ENGINE OIL LEAKAGE |
| 8. INSTALL CYLINDER HEAD COVER NO. 2 |
![]() |
Tighten the 2 A nuts, then the 2 B nuts.
| 9. INSTALL ENGINE UNDER COVER RH |