CAMSHAFT OIL CONTROL VALVE (for Sedan) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE ENGINE UNDER COVER RH |
| 3. REMOVE CYLINDER HEAD COVER NO. 2 |
![]() |
Remove the 4 nuts and cylinder head cover No. 2.
| 4. REMOVE FAN AND GENERATOR V BELT |
![]() |
Loosen bolts A and B.
Release the fan and generator V belt tension and remove the fan and generator V belt.
| 5. REMOVE FAN BELT ADJUSTING BAR |
![]() |
Remove the bolt and nut and remove the fan belt adjusting bar.
| 6. REMOVE CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY |
![]() |
Disconnect the camshaft timing oil control valve assembly connector.
![]() |
Remove the bolt and nut and remove the camshaft timing oil control valve assembly.
![]() |
Remove the O-ring from the camshaft timing oil control valve assembly.