CAN COMMUNICATION SYSTEM (for Sedan) > Power Steering ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Power Steering ECU Communication Stop Mode |
|
|

| 1.CHECK CAN BUS LINE FOR DISCONNECTION (POWER STEERING ECU MAIN WIRE) |
![]() |
Turn the ignition switch off.
Disconnect the D31 power steering ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D31-1 (CANH) - D31-7 (CANL) | Ignition switch off | 108 to 132 Ω |
| *a | Rear view of wire harness connector (to Power Steering ECU) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (IG, PGND) |
![]() |
Disconnect the A19 and D31 power steering ECU connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A19-2 (PGND) - Body ground | Always | Below 1 Ω |
| *a | Rear view of wire harness connector (to Power Steering ECU) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D31-6 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
|
| ||||
| OK | ||
| ||