CAN COMMUNICATION SYSTEM (for Sedan) > Center Airbag Sensor Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Center Airbag Sensor Communication Stop Mode |
|
|

| 1.CHECK CAN BUS LINE FOR DISCONNECTION (CENTER AIRBAG SENSOR ASSEMBLY BRANCH WIRE) |
![]() |
Turn the ignition switch off.
Disconnect the D16 center airbag sensor assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D16-13 (CANH) - D16-22 (CANL) | Ignition switch off | 54 to 69 Ω |
| *a | Rear view of wire harness connector (to Center Airbag Sensor Assembly) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (IG2, E1, E2) |
![]() |
Disconnect the D16 center airbag sensor assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D16-25 (E1) - Body ground | Always | Below 1 Ω |
| D16-26 (E2) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D16-21 (IG2) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Rear view of wire harness connector (to Center Airbag Sensor Assembly) |
|
| ||||
| OK | ||
| ||