CAN COMMUNICATION SYSTEM (for Sedan) > Air Conditioning Amplifier Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Air Conditioning Amplifier Communication Stop Mode |
|
|

| 1.CHECK CAN BUS LINE FOR DISCONNECTION (AIR CONDITIONING AMPLIFIER BRANCH WIRE) |
![]() |
Turn the ignition switch off.
Disconnect the E8 air conditioning amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E8-2 (TX+) - E8-3 (TX-) | Ignition switch off | 54 to 69 Ω |
| *a | Rear view of wire harness connector (to Air Conditioning Amplifier) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (IG+, GND) |
![]() |
Disconnect the E8 air conditioning amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E8-12 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E8-8 (IG+) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Rear view of wire harness connector (to Air Conditioning Amplifier) |
|
| ||||
| OK | ||
| ||