CAN COMMUNICATION SYSTEM (for Sedan) > Main Body ECU Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Main Body ECU Communication Stop Mode |
|
|

| 1.CHECK CAN BUS LINE FOR DISCONNECTION (MAIN BODY ECU BRANCH WIRE) |
![]() |
Turn the ignition switch OFF.
Disconnect the D33 main body ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| D33-23 (CANH) - D33-22 (CANL) | Ignition switch OFF | 54 to 69 Ω |
| *a | Rear view of wire harness connector (to Main Body ECU) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (BECU, IG, GND1) |
![]() |
Disconnect the 4B and 4E main body ECU connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 4E-17 (GND1) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 4B-30 (BECU) - Body ground | Always | 11 to 14 V |
| *a | Rear view of wire harness connector (to Main Body ECU) |
Reconnect the main body ECU connectors.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 4B-24 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Component with harness connected (Main Body ECU) |
|
| ||||
| OK | ||
| ||