METER / GAUGE SYSTEM (for Sedan) > TERMINALS OF ECU |
| COMBINATION METER ASSEMBLY |

Disconnect the D1 combination meter assembly connector.
Measure the voltage and resistance of the wire harness side connector.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
| D1-1 (IG2) - Body ground | B - Body ground | Ignition switch signal | Ignition switch OFF → ON | Below 1 V → 11 to 14 V |
| D1-2 (ECU-B) - Body ground | L - Body ground | Battery | Always | 11 to 14 V |
| D1-24 (ET) - Body ground | BR - Body ground | Ground | Always | Below 1 Ω |
Disconnect the D76 combination meter assembly connector.
Measure the voltage of the wire harness side connector.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
| D1-3 (FUEL) - Body ground | V - Body ground | Fuel level signal | Ignition switch ON | 11 to 14 V |
| D1-7 (ILL-) - Body ground | GR - Body ground | Light control rheostat signal | Ignition switch OFF → ON | Pulse generation (See waveform 1) |
| D1-14 (ILL+) - Body ground | G - Body ground | Illumination signal | Light control switch OFF → ON | Below 1 V → 11 to 14 V |
| D1-15 (TC) - Body ground | Y - Body ground | Tail cancel switch signal | Tail cancel switch OFF → ON | Below 1 V → 11 to 14 V |
| D1-16 (+S) - Body ground | SB - Body ground | Vehicle speed signal (Output) | Driving at approx. 20 km/h (12 mph) | Pulse generation (See waveform 2) |
| D1-17 (SI) - Body ground | P - Body ground | Vehicle Speed signal (Input) | Driving at approx. 20 km/h (12 mph) | Pulse generation (See waveform 2) |
| D1-20 (CANH) - Body ground | G - Body ground | CAN communication line | Ignition switch ON | Pulse generation |
| D1-21 (CANL) - Body ground | W - Body ground | CAN communication line | Ignition switch ON | Pulse generation |
| D76-1 (CHG) - Body ground | L - Body ground | Charge warning light signal | Ignition switch ON Engine start Charge warning light OFF → ON | 11 to 14 V → Below 1 V |
| D76-2 (SW) - Body ground | V - Body ground | Brake fluid level warning light signal | Ignition switch ON Brake fluid level warning light ON → OFF | Below 1 V → 11 to 14 V |
| D76-4 (EFI) - Body ground | B - Body ground | MIL signal | Ignition switch ON MIL ON → OFF | Below 1 V → 11 to 14 V |
| D76-7 (FOG) - Body ground*1 | R - Body ground | Front fog signal | Ignition switch ON Front fog light switch OFF → ON | Below 1 V → 11 to 14 V |
| D76-8 (TURN L) - Body ground | LG - Body ground | Turn signal LH signal | Ignition switch ON Turn signal LH indicator light OFF → ON → OFF | Below 1 V → 11 to 14 V → Below 1 V |
| D76-9 (PBLT) - Body ground | BE - Body ground | Seat belt warning light signal (Passenger side) | Ignition switch ON Front passenger seat belt warning light OFF → ON → OFF | Below 1 V → 11 to 14 V → Below 1 V |
| D76-11 (BEAM-) - Body ground | P - Body ground | HI-BEAM indicator signal (-) | Headlight dimmer switch (Hi-BEAM) Hi → Lo | Below 1 V → 11 to 14 V |
| D76-12 (S) - Body ground | Y - Body ground | Oil pressure signal | OIL / P warning light ON → OFF | Below 1 V → 11 to 14 V |
| D76-14 (BEAM+) - Body ground | GR - Body ground | HI-BEAM indicator signal (+) | BEAM indicator light OFF → ON | Below 1 V → 11 to 14 V |
| D76-15 (TURN R) - Body ground | BR - Body ground | Turn signal RH signal | Turn signal RH indicator light OFF → ON → OFF | Below 1 V → 11 to 14 V → Below 1 V |
| D76-16 (IND) - Body ground | G - Body ground | Taillight indicator signal | Light control switch OFF → ON | Below 1 V → 11 to 14 V |
| D76-17 (ODO) - Body ground | L - Body ground | ODO/TRIP switch signal | Ignition switch ON | 5 V |
| D76-18 (CLK) - Body ground | R - Body ground | Clock switch signal | Ignition switch ACC | 5 V |
| D76-19 (E1) - Body ground | GR - Body ground | Ground | Ignition switch ON | Below 1 V |
![]() |
Waveform 1: Using an oscilloscope
| Terminal Connections | D1-7 (ILL-) - Body Ground |
| Tool Setting | 5 V/DIV., 50 ms./DIV. |
| Condition | Ignition switch ON |
![]() |
Waveform 2: Using an oscilloscope
| Terminal Connections | D1-16 (+S) - Body Ground D1-17 (SI) - Body Ground |
| Tool Setting | 5 V/DIV., 20 ms./DIV. |
| Condition | Driving at approximately 12 mph (20 km/h) |
| MAIN BODY ECU |

| *1 | Rear view of Main Body ECU | - | - |

| *1 | Front view of Main Body ECU | - | - |
Disconnect the 4A, 4D and 4E main body ECU connectors.
Measure the resistance of the wire harness side connectors.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
| 4A-5 (RRCY) - Body ground | G - Body ground | Rear door courtesy switch signal (LH and RH) | Rear door (LH and RH) CLOSED → OPEN | 10 kΩ or higher → Below 1 Ω |
| 4A-7 (LGCY) - Body ground | SB - Body ground | Luggage door courtesy switch signal | Luggage door CLOSED → OPEN | 10 kΩ or higher → Below 1 Ω |
| 4A-21 (DCTY) - Body ground | R - Body ground | Front door courtesy switch signal (Driver Side) | Front door (Driver Side) CLOSED → OPEN | 10 kΩ or higher → Below 1 Ω |
| 4A-24 (PCTY) - Body ground | L - Body ground | Front door courtesy switch signal (Passenger Side) | Front door (Passenger Side) CLOSED → OPEN | 10 kΩ or higher → Below 1 Ω |
| 4D-7 (KSW) - Body ground | Y - Body ground | Key unlock warning switch signal | Key inserted → removed | 10 kΩ or higher → Below 1 Ω |
| 4E-17 (GND1) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
Reconnect the main body ECU connectors.
Measure the voltage of the wire harness side connectors.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
| 4C-2 (PKB) - Body ground | Y - Body ground | Parking brake signal | Parking brake warning light ON → OFF | Below 1 V → 11 to 14 V |
| D33-22 (CANL) - Body ground | W - Body ground | CAN communication line | Ignition switch ON | Pulse generation |
| D33-23 (CANH) - Body ground | R - Body ground | CAN communication line | Ignition switch ON | Pulse generation |
| COMBINATION METER INTERNAL CIRCUIT |



| Terminal No. | Wire Harness Side | |
| D1 | 1 | Ignition switch |
| 2 | Battery | |
| 3 | Fuel sender gauge assembly | |
| 7 | Light control rheostat | |
| 14 | Taillight relay | |
| 15 | Light control rheostat | |
| 16 | Other ECU | |
| 17 | Speedometer sensor | |
| 20 | CAN communication line | |
| 21 | CAN communication line | |
| 24 | Body ground | |
| D76 | 1 | Generator |
| 2 | Brake fluid level warning switch | |
| 4 | ECM | |
| 7*1 | Fog light relay | |
| 8 | Turn signal flasher relay | |
| 9 | Hazard warning signal switch assembly | |
| 11 | Headlight dimmer switch | |
| 12 | Engine oil pressure switch | |
| 14 | Headlight dimmer switch | |
| 15 | Turn signal flasher relay | |
| 16 | Taillight relay | |
| 17 | Hazard warning signal switch assembly | |
| 18 | Hazard warning signal switch assembly | |
| 19 | Hazard warning signal switch assembly | |