Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM (for Sedan)

METER / GAUGE SYSTEM (for Sedan) > Entire Combination Meter does not Operate


DESCRIPTION

This circuit provides power to the combination meter assembly.

WIRING DIAGRAM


E133669E01


INSPECTION PROCEDURE

1.CHECK FUSE (ECU-B, MET)


    E117120E01
  1. Remove the ECU-B fuse from the engine room relay block.

  1. Remove the MET fuse from the main body ECU.

  1. Measure the resistance.

    Standard Resistance:
    Below 1Ω

  1. Reinstall the fuse.



NG
CHECK SHORT CIRCUIT IN COMPONENTS AND WIRES CONNECTED TO FUSE
OK


2.INSPECT COMBINATION METER ASSEMBLY


    E114496E06
  1. Disconnect the D1 combination meter connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    D1-24 (ET) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    D1-1 (IG2) - Body ground
    Ignition switch ON
    11 to 14V
    D1-2 (ECU-B) - Body ground
    Always
    11 to 14V

  1. Reconnect the combination meter connector.



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)