METER / GAUGE SYSTEM (for Sedan) > Fuel Gauge Malfunction |

| 1.PERFORM ACTIVE TEST USING TECHSTREAM (FUEL GAUGE) |
![]() |
Connect the Techstream to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Fuel Meter Operation | Fuel gauge | EMPTY: Segment No.1 flashes. 1/2: Segments No.1 to 4 illuminates. FULL: Segments No.1 to 8 illuminates. | - |
|
| ||||
| OK | |
| 2.READ VALUE USING TECHSTREAM (FUEL GAUGE) |
Connect the Techstream to the DLC3.
Turn the ignition switch ON and turn the tester ON
Select the item below from the Data List, and read the value displayed on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Fuel Input(A/D) | Fuel input signal / Min.: 0 Max.: 255 | Fuel receiver gauge segments No.1 to No.8 illuminate: 14 to 34 No.1 to (No.6, No.7) illuminate: 77 to 109 No.1 to (No.4, No.5) illuminate: 135 to 172 No.1 to No.2 illuminate: 175 to 188 No.1 flashes: 194 to 200 | - |
|
| ||||
| OK | |
| 3.CHECK COMBINATION METER ASSEMBLY |
![]() |
Disconnect the J5 fuel sender gauge assembly connector.
Remove the combination meter assembly with its connectors connected.
Measure the voltage.
| Tester Connection | Condition | Specified Condition |
| D1-3 (FUEL) - Body ground | Ignition switch ON | 11 to 14V |
Reconnect the fuel sender gauge assembly connector.
Reinstall the combination meter assembly.
|
| ||||
| OK | |
| 4.INSPECT FUEL SENDER GAUGE ASSEMBLY |
Remove the fuel sender gauge assembly.

Check that the float position is between E and F.
Measure the resistance between terminals 2 and 1 of the fuel sender gauge connector.
| Float Level | Float Position (mm (in.)) | Specified Condition |
| F | 146.2 (5.76) to 158.2 (6.23) | 13.5 Ω to 16.5 Ω |
| 1/2 | 76.4 (3.01) to 88.4 (3.48) | 195.3 Ω to 221.3 Ω |
| E | 0 (0) | 405.5 Ω to 414.5 Ω |
Reinstall the fuel sender gauge assembly.
|
| ||||
| OK | |
| 5.CHECK WIRE HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - FUEL SENDER GAUGE ASSEMBLY) |
![]() |
Disconnect the D1 combination meter assembly connector.
Disconnect the J5 fuel sender gauge assembly connector.
Measure the resistance.
| Tester Connection | Specified Condition |
| D1-3 (FUEL) - J5-2 | Below 1Ω |
| J5-3 - Body ground | Below 1Ω |
Reconnect the combination meter assembly and fuel sender gauge assembly connectors.
|
| ||||
| OK | ||
| ||