METER / GAUGE SYSTEM (for Sedan) > Malfunction in Water Temperature Warning Light |

| 1.PERFORM ACTIVE TEST USING TECHSTREAM (COOLANT HOT) |
Connect the Techstream to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Body Electrical / Combination Meter / Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Water Temperature Meter Operation | Engine coolant temperature warning light and indicator light | LOW: Engine coolant temperature indicator light illuminates. NORMAL: Both engine coolant temperature warning light and indicator light turn off. HIGH: Engine coolant temperature warning light flashes. | - |
| Indicat. Lamp Coolant Cool | Engine coolant temperature indicator light | OFF/ON | Vehicle is stopped and engine is idling |
| Indicat. Lamp Coolant Hot | Engine coolant temperature indicator light | OFF/ON | Vehicle is stopped and engine is idling |
|
| ||||
| OK | |
| 2.READ VALUE USING TECHSTREAM (COOLANT TEMP) |
Connect the Techstream to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Select the item below from the Data List, and read the value displayed on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Coolant Temperature | Engine coolant temperature / Min.: 0°C,Max.: 127.5°C | After warming up: 75 to 105°C (167 to 221°F) | - |
|
| ||||
| OK | ||
| ||