Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR (for Sedan)

ENGINE COOLANT TEMPERATURE SENSOR (for Sedan) > INSPECTION



1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR


A107631E08
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Condition
      Specified Condition
      Approximately 20°C (68°F)
      2.32 to 2.59 kΩ
      Approximately 80°C (176°F)
      0.310 to 0.326 kΩ

      NOTICE:
      When checking the engine coolant temperature sensor in water, keep the terminals dry. After the check, wipe the sensor dry.

      If the resistance is not as specified, replace the engine coolant temperature sensor.