Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR (for Sedan)

ENGINE COOLANT TEMPERATURE SENSOR (for Sedan) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. DRAIN ENGINE COOLANT

NOTICE:
To avoid the danger of being burned, do not remove the water filler cap sub-assembly while the engine and radiator assembly are still hot. Thermal expansion will cause hot coolant and steam to blow out from the radiator assembly.



    A302981E01
  1. Loosen the radiator drain cock plug.
    Text in Illustration 
    *1
    Water Filler Cap Sub-assembly
    *2
    Radiator Drain Cock Plug

  1. Remove the water filler cap sub-assembly, then drain coolant.



3. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


A115149
  1. Disconnect the engine coolant temperature sensor connector.



    A115150E01
  1. Using SST, remove the engine coolant temperature sensor.

    SST
    09817-33190