Home › Engine / Hybrid System › 1NZ-FE ENGINE CONTROL › CAMSHAFT POSITION SENSOR (for Sedan)

CAMSHAFT POSITION SENSOR (for Sedan) > INSPECTION



1. INSPECT CAMSHAFT POSITION SENSOR


A115147E01
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Temperature
      Specified Condition
      Cold
      1,630 to 2,740 Ω
      Hot
      2,065 to 3,225 Ω

      HINT:
      In the table above, the terms Cold and Hot refer to the temperature of the coils. Cold means approximately -10 to 50 °C (14 to 122 °F). Hot means approximately 50 to 100 °C (122 to 212 °F).

      If the resistance is not as specified, replace the camshaft position sensor.