Home › Engine / Hybrid System › 1NZ-FE LUBRICATION › OIL PUMP (for Hatchback)

OIL PUMP (for Hatchback) > REPLACEMENT

for Preparation Click here



1. REMOVE OIL PUMP SEAL


A166952E01
  1. Using a screwdriver with its tip wrapped in protective tape and the wood block, remove the oil pump seal.
    Text in Illustration 
    *1
    Protective Tape
    *2
    Wood block



2. INSTALL OIL PUMP SEAL


A166953E05
  1. Using SST and a hammer, tap in a new oil pump seal until its surface is flush with the oil pump assembly.
    Text in Illustration 
    *1
    Wood Block

    SST
    09950-60010   (09951-00250, 09951-00410, 09952-06010)
    09950-70010   (09951-07100)

    NOTICE:
    Do not tap the oil pump seal at an angle.

  1. Apply a light coat of MP grease to the oil pump seal lip.

    NOTICE:
    Keep the oil pump seal lip free of foreign matter.