CYLINDER HEAD (for Sedan) > DISASSEMBLY |
| 1. REMOVE WITH HEAD TAPER SCREW PLUG NO. 1 |
![]() |
Using a 10 mm socket hexagon wrench, remove the taper screw plug and the gasket.
| 2. REMOVE VALVE LIFTER |
Remove the 16 valve lifters from the cylinder head.
| 3. REMOVE WITH HEAD TAPER SCREW PLUG NO. 2 |
![]() |
Using an 8 mm hexagon wrench, remove the taper screw plug.
| 4. REMOVE OIL CONTROL VALVE FILTER |
| 5. REMOVE INTAKE VALVE |
![]() |
Using SST, compress the valve spring and remove the 2 retainer locks, retainer and valve spring.
| 6. REMOVE EXHAUST VALVE |
Using SST, compress the valve spring and remove the 2 retainer locks, retainer and valve spring.
| 7. REMOVE VALVE STEM OIL SEAL |
![]() |
Using needle-nose pliers, remove the oil seal.
| 8. REMOVE VALVE SPRING SEAT |
![]() |
Using compressed air and a magnetic finger, remove the valve spring seats.
| 9. REMOVE STUD BOLT |
| 10. REMOVE CAMSHAFT BEARING CAP SETTING RING PIN |