Home › Engine / Hybrid System › 1NZ-FE COOLING › WATER PUMP (for Sedan)

WATER PUMP (for Sedan) > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. DRAIN ENGINE COOLANT

NOTICE:
To avoid the danger of being burned, do not remove the water filler cap sub-assembly while the engine and radiator assembly are still hot. Thermal expansion will cause hot coolant and steam to blow out from the radiator assembly.



    A302981E01
  1. Loosen the radiator drain cock plug.
    Text in Illustration 
    *1
    Water Filler Cap Sub-assembly
    *2
    Radiator Drain Cock Plug

  1. Remove the water filler cap sub-assembly, then drain coolant.



3. REMOVE ENGINE UNDER COVER RH


4. REMOVE FAN & GENERATOR V BELT


    A116197E01
  1. Loosen bolts A and B.

  1. Release the fan and generator V belt tension and remove the fan and generator V belt.



5. REMOVE GENERATOR ASSEMBLY


A115418
  1. Remove the terminal cap.

  1. Separate the connector and the harness clamp.

  1. Remove the nut and remove terminal B.



    A115419E01
  1. Remove fan belt adjusting slider fixing bolts A and B and remove the fan belt adjusting slider.



    A115420E01
  1. Remove fixing bolt B and remove the generator.



6. REMOVE ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH


A245785E01
  1. Place a wooden block on a jack underneath the oil pan sub-assembly.
    Text in Illustration 
    *1
    Wooden Block

    NOTICE:
    To prevent the No. 2 oil pan sub-assembly from deforming, do not place any attachments onto the No. 2 oil pan sub-assembly.



    G100143
  1. Remove the 5 bolts, the nut and the engine mounting insulator sub-assembly RH from the transverse engine engine mounting bracket and the vehicle.



7. REMOVE WATER PUMP PULLEY


A116191E01
  1. Using SST, hold the water pump pulley.

    SST
    09960-10010   (09962-01000, 09963-00700)

  1. Remove the 3 bolts and remove the water pump pulley.



8. REMOVE ENGINE WATER PUMP ASSEMBLY


A116192
  1. Remove the 3 bolts and 2 nuts and remove the engine water pump assembly and gasket.