Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY (for Sedan)

REAR COMBINATION LIGHT ASSEMBLY (for Sedan) > INSTALLATION



1. INSTALL REAR COMBINATION LIGHT ASSEMBLY
  1. Engage the guide and pin to install the rear combination light assembly.

  1. Connect the connector.

  1. Install the 2 nuts.

    Torque:
    3.2 N*m{ 33 kgf*cm , 28 in.*lbf }



2. INSTALL LUGGAGE COMPARTMENT TRIM INNER COVER
  1. Install the luggage compartment trim inner cover with the 5 clips.



3. INSTALL REAR FLOOR FINISH PLATE


    B349025
  1. Engage the 8 claws and install the rear floor finish plate.

  1. Install the 2 clips.



4. INSTALL DECK FLOOR BOX LH
  1. Install the deck floor box LH.



5. INSTALL DECK FLOOR BOX RH

HINT:
Use the same procedure as for the LH side.



6. INSTALL SPARE WHEEL COVER ASSEMBLY


    B136270
  1. Install the spare wheel cover assembly.