Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY (for Sedan)

REAR COMBINATION LIGHT ASSEMBLY (for Sedan) > REMOVAL


HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.



1. REMOVE SPARE WHEEL COVER ASSEMBLY


    B136270
  1. Remove the spare wheel cover assembly.



2. REMOVE DECK FLOOR BOX LH


    E129683
  1. Remove the deck floor box LH.



3. REMOVE DECK FLOOR BOX RH

HINT:
Use the same procedure as for the LH side.



4. REMOVE REAR FLOOR FINISH PLATE


    B349025
  1. Remove the 2 clips.

  1. Disengage the 8 claws and remove the rear floor finish plate.



5. REMOVE LUGGAGE COMPARTMENT TRIM INNER COVER


    E127139
  1. Remove the 5 clips and remove the luggage compartment trim inner cover.



6. REMOVE REAR COMBINATION LIGHT ASSEMBLY


    E127140
  1. Remove the 2 nuts.

  1. Disconnect the connector.



    E277531E01
  1. Disengage the guide and pin to remove the rear combination light assembly.
    Text in Illustration 
    *a
    Guide
    *b
    Pin