Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY (for Sedan)

REAR COMBINATION LIGHT ASSEMBLY (for Sedan) > DISASSEMBLY



1. REMOVE REAR COMBINATION LIGHT BODY GASKET


    E125483
  1. Remove the rear combination light body gasket.

    NOTICE:
    1. Detach the gasket if it adheres to the body.
    2. Do not reuse a removed gasket.
      Replace it with a new one to prevent water from entering.



2. REMOVE TAIL LIGHT AND STOP LIGHT BULB


    E125484
  1. Turn the tail light and stop light bulb socket and bulb, in the direction indicated by the arrow in the illustration, to remove them.

  1. Remove the tail light and stop light bulb from the light socket.



3. REMOVE TURN SIGNAL LIGHT BULB


    E125485
  1. Turn the turn signal light bulb socket and bulb, in the direction indicated by the arrow in the illustration, to remove them.

  1. Remove the turn signal light bulb from the light socket.



4. REMOVE BACK UP LIGHT BULB


    E125486
  1. Turn the back up light bulb socket and bulb, in the direction indicated by the arrow in the illustration, to remove them.

  1. Remove the back up light bulb from the light socket.