PERSONAL LIGHT (for Sedan) > INSPECTION |
| 1. INSPECT MAP LIGHT ASSEMBLY |
![]() |
Check the resistance.
Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | OFF | 10 kΩ or higher |
| 1 - 2 | Drivers switch ON | Below 1 Ω |
| 1 - 2 | Passengers switch OFF | Below 1 Ω |
Check the light operation.
Connect the positive (+) battery lead to terminal 1 and the negative (-) battery lead to terminal 2, then check that the light illuminates.