Home › Vehicle Interior › LIGHTING (INT) › ROOM LIGHT (for Sedan)

ROOM LIGHT (for Sedan) > REMOVAL



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE ROOM LIGHT ASSEMBLY


E114441E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the room light lens.



    B124365E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the 2 covers.



    E114442E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws.



    E114443E01
  1. Disengage the roof wire from the claw of the room light.

  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 4 claws and remove the room light switch base.

  1. Remove room light bulb No. 1.