HEADLIGHT DIMMER SWITCH (for Sedan) > INSPECTION |
| 1. INSPECT HEADLIGHT DIMMER SWITCH |
![]() |
Check the resistance of the light control switch.
Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 10 - 11 - 12 - 13 | OFF | 10 kΩ or higher |
| 10 - 13 | TAIL | Below 1 Ω |
| 10 - 13 | HEAD | Below 1 Ω |
| 11 - 12 | HEAD | Below 1 Ω |
Check the resistance of the headlight dimmer switch.
Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 9 - 11 | FLASH | Below 1 Ω |
| 8 - 11 | LOW BEAM | Below 1 Ω |
| 9 - 11 | HI BEAM | Below 1 Ω |
Check the resistance of the turn signal switch.
Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 6 - 7 | Right turn | Below 1 Ω |
| 5 - 6 - 7 | Neutral | 10 kΩ or higher |
| 5 - 7 | Left turn | Below 1 Ω |
w/ Front fog light:
Check the resistance of the front fog light switch.
Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 - 4 | OFF | 10 kΩ or higher |
| 3 - 4 | Front fog light switch ON | Below 1 Ω |