Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH (for Sedan)

HAZARD WARNING SWITCH (for Sedan) > INSTALLATION



1. INSTALL HAZARD WARNING SIGNAL SWITCH


    E127122
  1. Engage the 3 claws and remove the hazard warning signal switch.



2. INSTALL INSTRUMENT PANEL CENTER REGISTER


    E127121
  1. Engage the 8 claws and the instrument panel center register.



3. INSTALL INSTRUMENT CLUSTER FINISH PANEL CENTER SUB-ASSEMBLY
  1. Engage the 2 claws and 4 clips and install the instrument cluster finish panel center.



4. INSTALL INSTRUMENT CLUSTER FINISH PANEL NO.1


E116833
  1. Fit the 2 claws of the instrument cluster finish panel into the upper instrument cluster finish panel center.



    E116834
  1. Engage the 5 claws and 5 clips and install the instrument cluster finish panel.



5. INSTALL INSTRUMENT PANEL FINISH PANEL END LH


B132317
  1. Engage the 6 claws and 3 clips and install the instrument panel finish panel end LH.



6. INSTALL INSTRUMENT PANEL FINISH PANEL END RH


B132318
  1. Engage the 6 claws and 3 clips and install the instrument panel finish panel end RH.



7. INSTALL INSTRUMENT PANEL FINISH PANEL LOWER CENTER


B132316
  1. Engage the 2 claws and 2 clips and install the instrument panel finish panel lower center.