HAZARD WARNING SWITCH (for Sedan) > INSPECTION |
| 1. INSPECT HAZARD WARNING SIGNAL SWITCH |
![]() |
Check the resistance.
Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 4 - 15 | OFF | 10 kΩ or higher |
| 4 - 15 | ON | Below 1 Ω |
| 3 - 13 | Illumination circuit | Below 1 Ω |
Check the illumination operation.
Connect the positive (+) battery lead to terminal 13 and the negative (-) battery lead to terminal 3, then check that the illumination illuminates.