Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH (for Sedan)

STOP LIGHT SWITCH (for Sedan) > INSTALLATION



1. INSTALL STOP LIGHT SWITCH


    E167768
  1. Insert the stop light switch until the rod hits the brake pedal.

    HINT:
    When inserting the stop light switch, support the pedal from behind so that the pedal is not pushed in.



    E167769
  1. Make a quarter turn clockwise to install the stop light switch.

    HINT:
    When inserting the stop light switch, support the pedal from behind so that the pedal is not pushed in.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf } or less

  1. Check the protrusion of the rod.

    Protrusion of the rod:
    0.5 to 2.6 mm (0.020 to 0.102 in.)

  1. Connect the stop light switch connector to the stop light switch.