Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH (for Sedan)

STOP LIGHT SWITCH (for Sedan) > INSPECTION



1. INSPECT STOP LIGHT SWITCH


    B113724E04
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - 2
      Switch pin released
      Below 1 Ω
      3 - 4
      10 kΩ or higher
      1 - 2
      Switch pin pushed in
      10 kΩ or higher
      3 - 4
      Below 1 Ω

      If the result is not as specified, replace the stop light switch.