Home › Vehicle Interior › LIGHTING (INT) › FRONT DOOR COURTESY SWITCH (for Sedan)

FRONT DOOR COURTESY SWITCH (for Sedan) > INSTALLATION



1. INSTALL FRONT DOOR COURTESY SWITCH


E113843
  1. Connect the connector.

  1. Using "Torx" socket wrench T30, install the front door courtesy switch with the screw.

    Torque:
    3.7 N*m{ 38 kgf*cm , 33 in.*lbf }



2. INSTALL CENTER PILLAR GARNISH LOWER
  1. Engage the 2 clips and 3 claws and install the center pillar lower garnish.



3. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP


E127715
  1. Install the rear door opening trim weatherstrip.



4. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP


E127714
  1. Install the front door opening trim weatherstrip.



5. INSTALL REAR DOOR SCUFF PLATE
  1. Engage the 7 claws and install the rear door scuff plate.



6. INSTALL FRONT DOOR SCUFF PLATE
  1. Engage the 11 claws and install the front door scuff plate.



7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m{ 55 kgf*cm , 48 in.*lbf }