Home › Vehicle Interior › LIGHTING (INT) › FRONT DOOR COURTESY SWITCH (for Sedan)

FRONT DOOR COURTESY SWITCH (for Sedan) > INSPECTION



1. INSPECT FRONT DOOR COURTESY SWITCH


    B123004E05
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 - Switch body
      ON (Shaft not pressed)
      Below 1 Ω
      1 - Switch body
      OFF (Shaft pressed)
      10 kΩ or higher

      If the result is not as specified, replace the front door courtesy switch.