FRONT WIPER MOTOR (for Sedan) > INSTALLATION |
| 1. INSTALL FRONT WIPER MOTOR |
![]() |
Install the front wiper motor with the 3 bolts.
Apply DENSO No. 50 grease to the crank arm pivot of the front wiper motor.
![]() |
Install the rod onto the crank arm pivot of the front wiper motor.
| 2. INSTALL FRONT WIPER MOTOR AND LINK |
![]() |
Connect the connector.
Slide the wiper link as shown in the illustration and engage the rubber pin with the body.
Install the front wiper motor and link with the 2 bolts.
| 3. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY |
![]() |
Connect the washer hoses.
Engage the 5 hooks.
![]() |
Engage the 8 hooks and the 4 claws.
Install the cowl top ventilator louver sub-assembly with the 3 clips.
| 4. INSTALL COWL SIDE VENTILATOR SUB-ASSEMBLY LH |
![]() |
Engage the 3 claws and install the cowl side ventilator sub-assembly LH.
| 5. INSTALL COWL SIDE VENTILATOR SUB-ASSEMBLY RH |
| 6. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH |
![]() |
Scrape any metal powder off the serrated part of the wiper arm with a round file or the equivalent (when reinstalling).
Clean the wiper pivot serrations with a wire brush.
Operate the wiper, then stop the windshield wiper motor in the automatic stop position.
![]() |
Align the blade tip with the mark on the windshield glass, as shown in the illustration.
Tighten the nut of the front wiper arm.
| 7. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH |
![]() |
Scrape any metal powder off the serrated part of the wiper arm with a round file or the equivalent (when reinstalling).
Clean the wiper pivot serrations with a wire brush.
Operate the wiper, then stop the windshield wiper motor in the automatic stop position.
![]() |
Align the blade tip with the mark on the windshield glass, as shown in the illustration.
Tighten the nut of the front wiper arm.
| 8. INSTALL FRONT WIPER ARM HEAD CAP |
![]() |
Engage the claw and install the 2 front wiper arm head caps.
| 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |