Home › Vehicle Exterior › WIPER / WASHER › WASHER LEVEL WARNING SWITCH (for Sedan)

WASHER LEVEL WARNING SWITCH (for Sedan) > INSTALLATION



1. INSTALL WASHER LEVEL WARNING SWITCH


    E129627
  1. Install the washer level warning switch onto the packing of the washer jar.



2. INSTALL WINDSHIELD WASHER JAR ASSEMBLY


    E129625
  1. Install the windshield washer jar.



    E129623
  1. Install the 2 bolts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the 2 connectors.

  1. Connect the 2 harness clamps.



3. FILL UP WASHER JAR AND PUMP ASSEMBLY WITH WASHER FLUID
  1. Connect the washer hose to the washer motor and pump, and fill the washer jar with washer fluid.



4. INSTALL HEADLIGHT ASSEMBLY RH

HINT:
Use the same procedure as for the LH side .



5. REMOVE FRONT BUMPER COVER
(Click here)