Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR (for Sedan)

WASHER MOTOR (for Sedan) > INSTALLATION



1. INSTALL WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY


    E129624
  1. Install the windshield washer motor and pump onto the packing of the washer jar.



2. INSTALL WINDSHIELD WASHER JAR ASSEMBLY


    E129625
  1. Install the windshield washer jar.



    E129623
  1. w/ Washer Level Warning Switch

    1. Install the 2 bolts.

      Torque:
      5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

    2. Connect the 2 connectors.

    3. Connect the 2 harness clamps.

  1. w/o Washer level warning switch

    1. Install the 2 bolts.

      Torque:
      5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

    2. Connect the connector.

    3. Connect the 2 harness clamps.



3. FILL UP WASHER JAR AND PUMP ASSEMBLY WITH WASHER FLUID
  1. Connect the washer hose to the washer motor and pump, and fill the washer jar with washer fluid.



4. INSTALL HEADLIGHT ASSEMBLY RH

HINT:
Use the same procedure as for the LH side .



5. INSTALL FRONT BUMPER COVER
(Click here)