Home › Vehicle Exterior › WIPER / WASHER › WASHER MOTOR (for Sedan)

WASHER MOTOR (for Sedan) > REMOVAL



1. REMOVE FRONT BUMPER COVER
(Click here)


2. REMOVE HEADLIGHT ASSEMBLY RH

HINT:
Use the same procedure as for the LH side .



3. DRAIN WASHER FLUID
  1. Disconnect the washer hose from the windshield washer motor and pump, and drain the washer fluid.



4. REMOVE WINDSHIELD WASHER JAR ASSEMBLY


    E129623
  1. w/ Washer Level Warning Switch

    1. Disconnect the 2 harness clamps.

    2. Disconnect the 2 connectors.

    3. Remove the 2 bolts.

    4. Remove the windshield washer jar.

  1. w/o Washer Level Warning Switch

    1. Disconnect the 2 harness clamps.

    2. Disconnect the connector.

    3. Remove the 2 bolts.

    4. Remove the windshield washer jar.



5. REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY


    E129624
  1. Pull the washer motor and pump out of the packing of the washer jar.