Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW MASTER SWITCH (for Sedan)

POWER WINDOW MASTER SWITCH (for Sedan) > INSPECTION



1. INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY


    B107909E13
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the tables below.

      Standard Resistance:
      Driver switch:

      Window Lock Switch Condition
      Power Window Switch Condition
      Tester Connection
      Specified Condition
      Always
      (ON / OFF)
      UP
      3 (U) - 6 (B)
      1 (E) - 4 (D)
      Below 1 Ω
      Always
      (ON / OFF)
      OFF
      1 (E) - 3 (U)
      1 (E) - 4 (D)
      Below 1 Ω
      Always
      (ON / OFF)
      DOWN MANUAL
      4 (D) - 6 (B)
      1 (E) - 3 (U)
      Below 1 Ω
      Always
      (ON / OFF)
      DOWN AUTO
      1 (E) - 3 (U)
      4 (D) - 6 (B)
      Below 1 Ω

      If the result is not as specified, replace the power window regulator master switch.

      Standard Resistance:
      Passenger side switch:

      Window Lock Switch Condition
      Power Window Switch Condition
      Tester Connection
      Specified Condition
      OFF
      UP
      6 (B) - 16 (U)
      1 (E) - 15 (D)
      Below 1 Ω
      OFF
      OFF
      1 (E) - 16 (U)
      1 (E) - 15 (D)
      Below 1 Ω
      OFF
      DOWN
      6 (B) - 15 (D)
      1 (E) - 16 (U)
      Below 1 Ω
      ON
      UP
      6 (B) - 16 (U)
      Below 1 Ω
      ON
      UP
      1 (E) - 15 (D)
      10 kΩ or higher
      ON
      OFF
      15 (D) - 16 (U)
      Below 1 Ω
      ON
      DOWN
      6 (B) - 15 (D)
      Below 1 Ω
      ON
      DOWN
      1 (E) - 16 (U)
      10 kΩ or higher

      If the result is not as specified, replace the power window regulator master switch.

      Standard Resistance:
      Rear LH side switch:

      Window Lock Switch Condition
      Power Window Switch Condition
      Tester Connection
      Specified Condition
      OFF
      UP
      6 (B) - 12 (U)
      1 (E) - 13 (D)
      Below 1 Ω
      OFF
      OFF
      1 (E) - 12 (U)
      1 (E) - 13 (D)
      Below 1 Ω
      OFF
      DOWN
      6 (B) - 13 (D)
      1 (E) - 12 (U)
      Below 1 Ω
      ON
      UP
      6 (B) - 12 (U)
      Below 1 Ω
      ON
      UP
      1 (E) - 13 (D)
      10 kΩ or higher
      ON
      OFF
      12 (U) - 13 (D)
      Below 1 Ω
      ON
      DOWN
      6 (B) - 13 (D)
      Below 1 Ω
      ON
      DOWN
      1 (E) - 12 (U)
      10 kΩ or higher

      If the result is not as specified, replace the power window regulator master switch.

      Standard Resistance:
      Rear RH side switch:

      Window Lock Switch Condition
      Power Window Switch Condition
      Tester Connection
      Specified Condition
      OFF
      UP
      6 (B) - 10 (U)
      1 (E) - 18 (D)
      Below 1 Ω
      OFF
      OFF
      1 (E) - 10 (U)
      1 (E) - 18 (D)
      Below 1 Ω
      OFF
      DOWN
      6 (B) - 18 (D)
      1 (E) - 10 (U)
      Below 1 Ω
      ON
      UP
      6 (B) - 10 (U)
      Below 1 Ω
      ON
      UP
      1 (E) - 18 (D)
      10 kΩ or higher
      ON
      OFF
      10 (U) - 18 (D)
      Below 1 Ω
      ON
      DOWN
      6 (B) - 18 (D)
      Below 1 Ω
      ON
      DOWN
      1 (E) - 10 (U)
      10 kΩ or higher

      If the result is not as specified, replace the power window regulator master switch.

  1. Check the illumination operation.

    1. Apply battery voltage to the power window regulator master switch and check that the illumination comes on.

      Standard:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 6 (B)
      Battery negative (-) → Terminal 1 (E)
      Illumination comes on

      If the result is not as specified, replace the power window regulator master switch.