REAR DOOR LOCK (for Sedan) > INSPECTION |
| 1. INSPECT REAR DOOR LOCK ASSEMBLY LH |
![]() |
w/ Power door lock:
Check the operation.
Apply battery voltage to the rear door lock and check the operation of the door lock motor.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 4 Battery negative (-) → Terminal 1 | Locks |
| Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 4 | Unlocks |
Check the resistance of the unlock detection switch.
Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.
| Tester Connection | Door Lock Condition | Specified Condition |
| 6 - 9 | Locked | 10 kΩ or higher |
| 6 - 9 | Unlocked | Below 1 Ω |
| 2. INSPECT REAR DOOR LOCK ASSEMBLY RH |
![]() |
w/ Power door lock:
Check the operation.
Apply battery voltage to the rear door lock and check the operation of the door lock motor.
| Measurement Condition | Specified Condition |
| Battery positive (+) → Terminal 4 Battery negative (-) → Terminal 1 | Locks |
| Battery positive (+) → Terminal 1 Battery negative (-) → Terminal 4 | Unlocks |
Check the resistance of the unlock detection switch.
Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below.
| Tester Connection | Door Lock Condition | Specified Condition |
| 6 - 9 | Locked | 10 kΩ or higher |
| 6 - 9 | Unlocked | Below 1 Ω |