Home › Engine / Hybrid System › 1NZ-FE STARTING › STARTER (for Sedan)

STARTER (for Sedan) > REMOVAL



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FLYWHEEL HOUSING SIDE COVER


A104497E01
  1. Disengage the claw while pushing it upward and remove the flywheel housing side cover.



3. REMOVE STARTER ASSEMBLY


A104498
  1. Remove the terminal cap.

  1. Remove the nut and remove terminal 30.

  1. Disconnect the connector.

  1. Remove the 2 bolts and remove the starter assembly.