Home › Engine / Hybrid System › 1NZ-FE STARTING › STARTER (for Hatchback Except Cold Area Specification Vehicles)

STARTER (for Hatchback Except Cold Area Specification Vehicles) > REMOVAL



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE FLYWHEEL HOUSING SIDE COVER


    A248646
  1. Disengage the claw by pulling it outward and remove the flywheel housing side cover.



4. REMOVE STARTER ASSEMBLY


A247237E01
  1. Open the terminal cap.

  1. Remove the nut and disconnect the terminal 30.

  1. Disconnect the connector.

  1. Remove the 2 bolts and the starter assembly.
    Text in Illustration 
    *1
    Terminal 30