Home › Engine / Hybrid System › 1NZ-FE STARTING › RELAY (for Sedan)

RELAY (for Sedan) > ON-VEHICLE INSPECTION



1. INSPECT STARTER RELAY


    E034090E03
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      3 - 5
      Below 1 Ω (when battery voltage applied to terminals 1 and 2)
      10 kΩ or higher

      If the result is not as specified, replace the relay.



2. INSPECT ACC CUT RELAY


    A030519E02
  1. Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      3 - 4
      Below 1 Ω
      10 kΩ or higher (when battery voltage applied to terminals 1 and 2)
      3 - 5
      Below 1 Ω (when battery voltage applied to terminals 1 and 2)
      10 kΩ or higher

      If the result is not as specified, replace the relay.