Home › Power Source / Network › 1NZ-FE BATTERY / CHARGING › GENERATOR (for Sedan)

GENERATOR (for Sedan) > REMOVAL



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE ENGINE UNDER COVER RH


3. REMOVE FAN & GENERATOR V BELT


    A116197E01
  1. Loosen bolts A and B.

  1. Release the fan and generator V belt tension and remove the fan and generator V belt.



4. REMOVE GENERATOR ASSEMBLY


A115418
  1. Remove the terminal cap.

  1. Separate the connector and the harness clamp.

  1. Remove the nut and remove terminal B.



    A115419E01
  1. Remove fan belt adjusting slider fixing bolts A and B and remove the fan belt adjusting slider.



    A115420E01
  1. Remove fixing bolt B and remove the generator.